The Starter PID Bundle Kit pairs a compact and versatile N1030 PID controller with a matched 25A Solid State Relay and 3-wire PT100 sensor (suitable for temperatures up to 400°C) — everything needed for a single-loop control application in one order. Well suited to packaging equipment, thermoplastics, catering equipment, brewing, and similar single-loop processes.
Contains:
1 x Novus N1030-PR Controller
1 x Novus 25A Solid State Relay
1 x PT100 Sensor (5 x 50mm, 2M cable, 420°C max)
✅ 3 year manufacturer warranty on the controller; 1 year on the included SSR and sensor
Novus N1030-PR Datasheet Download
Novus N1030-PR Manual Download
Read The PID Bundle Wiring & Setup Guide Online
Technical Details
Controller: N1030-PR, 1/16 DIN, thermocouple J/K/T and Pt100 input, pulse + relay outputs
SSR: 25A, 40-480VAC load, 3-32VDC control
Sensor: PT100, 5 x 50mm probe, 2M cable, rated to 420°C
Frequently Asked Questions
What's included in the bundle?
The N1030-PR controller, a matched 25A SSR, and a 3-wire PT100 sensor — no separate purchases needed to get a working single-loop control setup.
What warranty applies to the bundle?
3 years on the controller and 1 year on the SSR and sensor, since they're covered under different Novus warranty terms.
Is there a Type K thermocouple version instead of PT100?
Yes, see the Type K Starter Bundle.
Do I need a heatsink for the solid state relay?
In most installations, yes. A solid state relay gives off roughly 1.5W of heat per amp of load, so a 20A heater produces around 30W in the relay. Mount it on a heatsink rated for the relay and keep the panel below 40-50°C. For 25A relays the EMAS SSS2X heatsink is a good fit.
How do I tune the controller after installation?
Use the built-in autotune. A fast autotune at 50-60% of your normal working temperature sets sensible PID values, then a full autotune at working temperature can fine-tune them. Run initial tuning without interference i.e. changes to setpoint or environment. For ovens and kilns, ensure doors and access points are closed. The initial tuning should be as close as possible to normal operating conditions. See PID Tuning for step-by-step help.
Can you set up the controller before it is sent?
Yes. Add our Pre-Programming service to your order and tell us your sensor, setpoint and alarm requirements. We configure the controller before dispatch, so it is ready to wire in.
Where can I find wiring and setup instructions?
Our PID Bundle Guide: Wiring & Setup covers the power supply, sensor and SSR wiring, first-time setup and autotune. You can also download the PID Bundle Guide (PDF) to keep with the panel.
Industry Applications
- Packaging Equipment — complete single-loop control setup out of the box.
- Catering Equipment — PT100 accuracy for precise temperature-critical processes.
- Brewing & Thermoplastics — matched controller and SSR for reliable heating control.
Need a custom bundle, or advice on the best products for your project? Please contact us and we will tailor a solution to your requirement.



