32A 2-Pole Changeover Switch With Centre Off (1-0-2)
The EMAS PSA032KD234S is a panel-mounted rotary cam changeover switch rated 32A (AC21A). It has three positions, 1-0-2, with off in the centre, and switches two poles, so on a single-phase circuit both line and neutral are transferred together. Typical uses are selecting between two supplies (for example mains and an alternative supply) or switching one supply between two loads, with a guaranteed off position between them so the two sides are never connected together.
For heavier loads see the EMAS PSA063KD234S 63A changeover switch. For a simple on/off isolator see the EMAS PSA032AK341E 32A rotary isolator.
MPN PSA032KD234S
- 32A rated current, AC21A, 690V insulation voltage
- 1-0-2 changeover with centre off, 60° switching angle
- 2 poles, switches line and neutral together on single-phase circuits
- 64x64mm front plate, IP54
Safety note: where this switch is used to change over between two sources of supply (for example mains and a generator), the installation must be designed and fitted by a competent electrician in line with BS 7671, and must prevent the two supplies ever being connected in parallel. Check with your electricity supplier before connecting an alternative supply to a property.
EMAS PSA032KD234S Datasheet Download
Technical Details
| Product | Cam switch |
| Switch Type | Changeover |
| Positions | 1-0-2 |
| Poles | 2 |
| Frame Size | 64 x 64 mm |
| Current (Ie) | 32A |
| Usage Category | AC21A |
| Switching Angle | 60° |
| Mechanical Life | 100,000 operations (min.) |
| Electrical Life | 50,000 operations (min.) |
| Insulation Voltage (Ui) | 690V |
| Impulse Withstand Voltage (Uimp) | 4 kV |
| Operating Temperature | -25 / +80 °C |
| Protection Degree | IP54 |
| Contact Material | AgNi |
| Cable Section | 4 mm² |
| Short Circuit Breaking Capacity (Ics) | 6 kA |
| Standard | TS EN 60947-3 |
| Series | PSA Series |
Frequently Asked Questions
What does 1-0-2 mean?
Position 1 connects the common terminals to the first side, 0 is off with everything disconnected, and position 2 connects to the second side. The switch must pass through off when moving between 1 and 2.
Can I use it as a generator changeover switch?
It can form part of a manual changeover arrangement on a single-phase circuit up to 32A, because it switches both line and neutral and has a centre off. The installation must be designed and fitted by a competent electrician to BS 7671.
Is it suitable for switching motors?
It is rated AC21A, which covers resistive and mixed loads. For selecting or reversing motors, check the motor current against the switch rating and use a contactor where frequent switching under load is needed.
Does it come with an enclosure?
No. It is a panel-mounting switch with a 64x64mm front plate, for fitting into a door or enclosure lid.
Industry Applications
- Supply selection — manual changeover between two single-phase supplies with a guaranteed off position
- Load selection — switching one supply between two heaters, pumps or circuits
- Test & maintenance panels — selecting between duty and standby equipment
Troubleshooting & Guides
- Faultfinding — tracing supply and control circuit faults
- Knowledge Base — all our technical guides in one place